/*
 Voltaat learn (http://learn.voltaat.com)
 Link for full tutorial:
 RFID reader library:

 SPI library:It is included in the Arduino IDE by defulalt

 Tutorial: RFID reader for safe pass gate

 It is important to note that the RFID reader module operates on 3.3V not 5V,
 so we connected it with the 3.3V pin.

 Connections from the RFID reader to the Arduino:
 • RFID 3.3V pin → Arduino VCC (3.3V) pin
 • RFID RST pin → Arduino pin 9
 • RFID GND pin → Arduino GND pin
 • RFID IRQ pin → unconnected
 • RFID MISO pin → Arduino pin 12
 • RFID MOSI pin → Arduino pin 11
 • RFID SCK pin → Arduino pin 13
 • RFID SDA pin → Arduino pin 10

*/


//This library allows you to communicate with SPI devices
#include "SPI.h"
//This library allows you to use RFID reader
#include "MFRC522.h"

//Define RFID reader pins
#define SS_PIN 10
#define RST_PIN 9

//Create MFRC522 instance
MFRC522 mfrc522(SS_PIN, RST_PIN);



//Commands inside void setup run once
void setup()
{
 //Start the serial monitor at 9600 baud rate (9600 bits per second)
 Serial.begin(9600);
 //Initialize spi connection
 SPI.begin();
 //Initiate MFRC522
 mfrc522.PCD_Init();
 //Print to serial monitor
 Serial.println("Approximate your card to the reader...");
 Serial.println();

}

//Commands inside void loop run forever
void loop()
{
 //Look for new cards
 if ( ! mfrc522.PICC_IsNewCardPresent())
 {
   return;
 }

 //Select one of the cards
 if ( ! mfrc522.PICC_ReadCardSerial())
 {
   return;
 }

 //Print to serial monitor
 Serial.print("UID tag :");
 String content = "";
 byte letter;
 for (byte i = 0; i < mfrc522.uid.size; i++)
 {
   Serial.print(mfrc522.uid.uidByte[i] < 0x10 ? " 0" : " ");
   Serial.print(mfrc522.uid.uidByte[i], HEX);
   content.concat(String(mfrc522.uid.uidByte[i] < 0x10 ? " 0" : " "));
   content.concat(String(mfrc522.uid.uidByte[i], HEX));
 }
 Serial.println();
 Serial.print("Message : ");
 content.toUpperCase();
 //Make sure you change this with your own UID number
 if (content.substring(1) == "8A 21 EC 81")
 {
   //Print to serial monitor
   Serial.println("Authorised access, The gate will open");
   Serial.println();
   //Delay for 3 sec
   delay(3000);
 }

 else   {
   //Print to serial monitor
   Serial.println("Access denied, Please try again");
   //Delay for 3 sec
   delay(3000);
 }
}